|
SWT-01
Selector switch for bike audio systems with on-bike
speakers
 SWT-01
is designed to be used in conjunction with a MUS-03;
it allows the selection of sound to the on-bike
speakers and/or to the StarCom1:
1)
Speakers only.
2)
Speakers and StarCom1 headset.
3)
StarCom1 headset only.
Wiring installation:
1)
Locate the right speaker cable, identify the +ve
wire (this is usually marked with a white trace,
red wire or moulded rib in the wire) and cut the
single wire.
2)
Select the right cable set from
the SWT-01 (right viewing from the front,
correct way up) and connect the RED wire to the
+ve speaker wire on the audio
system side, connect the GREEN wire to the
speaker side. As shown above.
3)
Connect the BLUE wire to the
black/white wire on the MUS-03 cable.
4)
Connect the Black wire from MUS-03
to the –ve speaker wire.
5)
Repeat steps 1 to 4 for the left
speaker using the MUS-03 left cable.
6)
Ensure all wires are secured to
the bike and will not flap free
Switch
installation
Using the releasable ties on the rear
of the switch, secure it to a convenient position
allowing easy and safe access to operate the switch,
usually on or near the handlebars.
Warning
Incorrect connections may cause damage to your audio
system, if you are not confident it wiring the
system please consult your dealer.
All cabling should be installed so that it will not
flap free. There should be no cable slack that could
potentially catch in the moving parts of the
vehicle. The rider must be able to hear warnings
from other road users at all times. The volume must
be set at a level to allow this.
|
